Two resistors in series split a voltage in proportion to their values. Dividers scale sensor signals down to an ADC range, set reference voltages and bias transistors.
How to use this calculator
- Enter the input voltage and both resistors (R1 on top, R2 to ground).
- Optionally add the load resistance connected across R2 — it pulls the output down.
- Optionally enter a target output to get the R2 value you need.
Formula
Vout = Vin × R2 / (R1 + R2)Worked example
To read a 12 V battery with a 3.3 V ADC, use R1 = 30 kΩ and R2 = 10 kΩ: Vout = 12 × 10 / 40 = 3.0 V, leaving margin for a fully charged 13.8 V battery (3.45 V — slightly high, so 33 kΩ is safer).
Frequently asked questions
Why does my divider output drop when I connect a load?
The load sits in parallel with R2 and lowers its effective value. Keep the load at least 10× larger than R2, or buffer the output with an op-amp.
Can I power a circuit from a voltage divider?
Only very light loads. A divider wastes current and its output changes with the load — use a regulator instead.
Results are for learning and preliminary design. Check critical work against the relevant codes and a qualified engineer.