A resistor and capacitor set both how fast a capacitor charges and where a first-order RC filter starts to cut a signal.
How to use this calculator
- Enter R and C.
- Read τ, the time to about 99 % (5τ) and the −3 dB cut-off frequency.
- Optionally enter a time to see how far the capacitor has charged.
Formula
τ = R × C, fc = 1 / (2π R C), Vc/Vs = 1 − e^(−t/τ)Worked example
10 kΩ and 100 nF: τ = 1 ms, fully charged after about 5 ms, and fc = 159 Hz.
Frequently asked questions
Is the cut-off the same for low-pass and high-pass?
Yes. Swapping R and C positions changes the filter type but not the −3 dB frequency.
Why 5τ?
After 5 time constants the capacitor reaches 99.3 % of the final voltage, which engineers treat as fully charged.
Results are for learning and preliminary design. Check critical work against the relevant codes and a qualified engineer.