Check how much a beam bends and how hard it works. Covers the four standard cases: simply supported or cantilever, with a point load or a uniform load.
How to use this calculator
- Choose the support and the load type.
- Enter the span, the load, Young's modulus and the second moment of area of the section.
- Add the section modulus to get the bending stress.
Formula
δ = PL³/48EI (SS, centre load), 5wL⁴/384EI (SS, UDL), PL³/3EI (cantilever, end load), wL⁴/8EI (cantilever, UDL)Elastic, small-deflection theory; beam self-weight is not included unless you add it to the uniform load.
Worked example
A 4 m simply supported steel IPE 220 (I = 2772 cm⁴) with 10 kN at mid-span: δ = 2.4 mm (L/1663), M = 10 kN·m.
Frequently asked questions
What deflection limit should I use?
Typical limits are L/360 for floors with brittle finishes, L/250 for general floors and L/180 for cantilevers or roofs — check your code.
Where do I find I and Z?
In the section tables of the steel maker or a design handbook. For a rectangle b × h: I = bh³/12 and Z = bh²/6.
Results are for learning and preliminary design. Check critical work against the relevant codes and a qualified engineer.